Mishimoto 2018+ Ford Mustang GT Thermostatic Oil Cooler Kit - Silver MMOC-MUS8-18T

Part Number: misMMOC-MUS8-18T Description: Mishimoto 2018+ Ford Mustang GT Thermostatic Oil Cooler Kit - Silver TechSpec Rows: 12 TechSpec Core Construction: N/A TechSpec Core Length (in): 18.5 TechSpec Core Height (in): N/A TechSpec Core Thickness (in): N/A TechSpec Engine Codes: 5.0 Coyote III TechSpec Chassis Codes: S-550 TechSpec Installation Notes: N/A TechSpec Caution: It is the installer's responsibility to check all thermostat plugs, NPT plugs, line fittings, and other connections to assure they are fully tightened before operating the vehicle. Mishimoto recommends that you check all connections at regular intervals, especially during the first few miles after installation. TechSpec Overall Height (in): 2.5 TechSpec Overall Length (in): 28.6 TechSpec Overall Width (in): 12.3 TechSpec Inlet: N/A TechSpec Outlet: N/A TechSpec Includes: Application Specific Mounting Bracket / Air Diversion Shield--Bar and Plate Oil Cooler--2ft 3in Stainless Steel Braided Hose w/ -10AN Fittings--4ft 8in Stainless Steel Braided Hose w/ -10AN Fittings--M22 Thermostatic Sandwich Plate--Application - Specific, M22 x 1.5 extended length center bolt--M20 x -10AN Straight Fittings--1/8-in NPT Plugs--Large O-ring--Lower Radiator Hose w/ worm gear clamps--Mounting Hardware Set--Mishimoto Lifetime Warranty TechSpec Applications: N/A TechSpec Fluid Capacity (qts): 1 TechSpec Note: Requires the removal of the stock coolant based oil cooler.----Installation requires the removal of the active grill shutters. Removal without tuning can cause a check engine light.----Recommended torque specification for all straight fittings and banjo bolts: 15-25 lb-ftDo not exceed the maximum torque rating of 35 ft-lb SellingPoint10: Mishimoto Lifetime Warranty SellingPoint11: N/A SellingPoint12: N/A SellingPoint13: N/A SellingPoint14: N/A SellingPoint15: N/A SellingPoint01: Direct fit for the 2018-2023 Ford Mustang GT SellingPoint02: Innovative bar-and-plate oil cooler mounts in the upper grille, allowing more room for supercharger heat exchangers SellingPoint03: Mounting bracket also serves as an air diversion panel, directing the maximum amount of ambient air through the oil cooler SellingPoint04: Pre-made stainless steel braided oil lines with durable -AN fittings SellingPoint05: Comes with replacement lower radiator hose to bypass the stock fluid-based oil cooler SellingPoint06: Removes the stock fluid-based oil cooler for less stress on the engine's cooling system SellingPoint07: Billet aluminum thermostatic oil sandwich plate SellingPoint08: Increases oil capacity by 1qt SellingPoint09: Fits with most aftermarket supercharger kits Install Difficulty: 4 OptionLabel: Silver, Thermostatic